Yep.
Did it 3 times - each time hitting 40 psi. Rotated inbetween ..... same thought.
Not too worried now that I read more on it .... just was hoping to see it
Got the trans bolted in .....
Got the 1.5 lower coupling welded with a lip on each end for coolant ...
Got the Oil pressure sensor swapped out at back to dakota version - just because - claw wrench good here
Now just left to do 3-4 grounds and run power to the fuel tank and get fuel.
Unfortunately Im going to have to wait a bit until I get back from work ...
Ordered a heater line bend to block of the heater lines at thermostat.
slowly ....