The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - How did you get cab, box, burb, panel, blazer off the frame?

dz1087 · 12-03-2019, 01:47 PM

I took a piece of plywood and a 2x4, nailed them together, and stuck that plywood side first up in the roof of the cab. Then I used my engine lift and lifted the cab off by placing the boom against the 2x4. The plywood spread out the weight of the cab over most of the interior roof, so no dents or bends.

Name: cBMiCWL.jpg
Views: 133
Size: 50.9 KB

Name: cBMiCWL.jpg
Views: 133
Size: 50.9 KB

12-03-2019, 01:47 PM	#28
dz1087 Registered User Join Date: Feb 2019 Location: Navarre, Florida Posts: 199	Re: How did you get cab, box, burb, panel, blazer off the frame? I took a piece of plywood and a 2x4, nailed them together, and stuck that plywood side first up in the roof of the cab. Then I used my engine lift and lifted the cab off by placing the boom against the 2x4. The plywood spread out the weight of the cab over most of the interior roof, so no dents or bends.