Happy Monday Gents.
Wife was out of town all weekend so I got to spend another weekend slaving away in the garage.
I started over with the piece of pipe for my wastegate dump and got it looking/fitting better this go.
Welded my o2 bung
Made up a new, longer plug wire for the rear bank (cyl7? or 8?)
My 1st attemp at making a crossover hose with the new PTFE hose and fittings I got... didn't go well at well. The fittings are very tough to get into the PTFE line. Not sure if thats normal or what but I got them but not without a fight.
Finally got it made up.
I went ahead and finished welded all my hot site items. Cleaned them and sprayed them with VHT. I heat wrapped the crossover pipe then sprayed over it again.
My dummy self forgot to put gloves on using that wrap.. Its ITCHY!