Re: 57 Panel "FAKMLC" build
1) I currently have the Engine Harness hooked up and working. Looks like this.
12v battery is 30A fused.
Starter Solenoid goes through NSS and then to 30A relay.
Truck starts only in P=N and runs great.
But Now i need to tie in the EZ harness. I think it would go ....
1) The only power supply wire is the larger red wire labelled SOLENOID POWER -- which I would tie to the starter on the main side (opposite solenoid) for constant 12v.
2) The only other wires to make harness work would be
a)IGN SW IGN wire that would be tied to the IGN switch alongside with the engine/ls harness wire ..... or I guess just the EZ IGN wire - then join the IGN wire of the LS harness to the COIL wire of the EZ harness. Not sure it matters.
b) IGN SW ACC wire for accessories, lights ... so on.
|