Re: 68 Second Chance
So today was able to get the truck ready for the Utech paint spraying which will happen on Sunday morning. Was doing touch up glaze on few areas around the cab corner and rocker. Also got one more coat of primer on the interior floor cab corner that needs to be sprayed also.
While that was drying I started to reassemble the bench seat that I cleaned up and painted. Added new burlap material, cotton batting and had to do a few small foam repairs on the driver side area of the seat. After getting everything looking and feeling like it should I went ahead and install the seat cover. Only thing left to do on seat is install the seat mount brackets, slide bar linkage and pull the sides tight and put a few hog rings to hold them in place. This will help line up the upper welting to the lower section welting like it is intended.
Photo 1 - one of the areas that needs foam repair
Photo 2 - lower section after new burlap and cotton batting
Photo 3 - getting ready to trim of extra materials and install cover
Photo 4 - seat covers installed, still need sides fasten down and go over with heat gun to get a few of the wrinkles out
photo 5 - Cab corner ready for paint in the morning
|