TKO 600 going in
Been working on my TKO 600 conversion slowly but steadily. I am at the point that I need to cut a hole in the floor for the shifter. Right now I have the motor out, the bell housing dialed in and clutch installed. The trans has a 1" offset shifter and the cross member is not bolted.
I'm trying to figure out the best way to lay out the cut. I am working in my garage so the highest I can get the truck off the ground is a good set of jack stands (@ 18"). I am thinking I should install the motor w/o the trans, somehow level it, and measure from there. Then I would install the trans from the bottom...
Anyone with any suggestions or experience that might help, please chime in.
Thanks
|