|
Re: 1971 Stepside LS Build
Quote:
|
I assume you are going to just run one brake line down from the Wilwood prop valve to a T, then to both front calipers. The prop valve has provisions for running individual lines to both front wheels, but I'm unsure why it would be better than running a single line?
|
I ran two lines. One for the rear and one for the front. The front line hits that t-block you see in the above picture. It then runs to both front lines from there. That first pic is a little tricky in that the line to the passenger front brake is not installed yet.
__________________
1971 C10 Stepside. LSx 6.0 with BTR Stage IV, Speed Engineering Headers, 4L80e transmission w/3200 Circle-D Stall. 3.73. Posi. Purchased this truck when I was 17. I started the rebuild (or take apart) in 1993. I have drug it around all over the country in pieces. Finally back on the road in 2021.
"I can't complain, but sometimes I still do. Life's been good to me so far."
|