[Gregski]

Volumetric Efficiency VE Table Calibration

Let's just zoom in on that graph aka the right side of the previous screen shot.

This is pretty typical of what you may see, when doing this for the first time on your stock(ish) engine.

The factory likes to run these engines hot and lean do to fuel economy and emissions constraints.

We will take some liberties with these settings and tune for Power and Performance.

As with the MAF based on this data we could just go into the VCM Editor and bump the entire VE Table by 10% so multiply it by 1.10

again going from lean (pink) to rich (green) in such a big jump fashion is acceptable as you are not going to hurt anything by going fat and happy