Welp with the virus going around, I've been stuck working from home. It's taken some discipline to not wander up to the shop during the day
Finished the patch panels on one of the inner tubs. Just need to redrill the holes in the patches.
I spent some late nights working on the bed. On Tuesday my new bed floor pieces showed up. After getting it unloaded I realized that I had accidently ordered a long bed rear half panel. I was too motivated to wait on reordering the correct section so I dove in.
Took the recently blasted floor braces and por-15'd the interiors. They were in all pretty good shape!
While that dried, I started rolling on the body filler on the front bumper. It was already in good shape, so this should take care of any minor imperfections.
I used the old bed floor too verify measurements on the new sections. Added some tape for a guide to cut a long. Had to make an extra cut because of the incorrect rear section... Oh well, it's only my time
