[youngrodder]

Last night I worked on mounting my ECU under the seat. I had to notch thhe edge of the seat opening slightly to allow the computer to slid back some....I cut a 2.25" pass thru hole for the rubber grommet. I also used these simple ECU mounts that grab the ECU on the sides. To fasten these to the floor, I used nut zirts that I think are slick. Also while I was at it I needed to get a sneak peak of my gauges....I still need to make a small bracket to mount a small fuse panel from the LS (BP Automotive) wiring harness.

Thanks
Marc