Figured I would add some photos of the mock-up I just completed. For those considering this kit, I will say it makes life pretty simple..
I started first by simply installing the brackets to get an idea of how it will look, and to ensure I had nothing interfering both inside and outside the firewall.
Then I marked and drilled the two mounting holes and inserted hardware to just to make sure the hole saw would not move the bracket around while drilling the center hole.
Things look good at this point, now onto adding the master cylinder and linkage
[IMG]
While this was not the final assembly, its obvious how well this went together. Once I get a bit farther in my project, it will all go back in for the final time.
Now understanding no two of these trucks are identical, (and I am a bit anal), I shaved a few thousands off the standoff to provide perfect alignment.
Last step was to ensure the the rod was level, mark the clutch pedal and drill the mounting hole..
Thanks,
Drew