|
Re: Firewall Extension Panel?
Buy a piece of sheet metal and cut it out. I mocked up by tracing the drivers side on cardboard to make sure the curve matched and then cut the cardboard to fit the shape of the missing blower motor spot and then transferred it to the metal. Wasn't too hard to do. I wasn't aware that you could buy just that piece.
__________________
1971 C10 Stepside. LSx 6.0 with BTR Stage IV, Speed Engineering Headers, 4L80e transmission w/3200 Circle-D Stall. 3.73. Posi. Purchased this truck when I was 17. I started the rebuild (or take apart) in 1993. I have drug it around all over the country in pieces. Finally back on the road in 2021.
"I can't complain, but sometimes I still do. Life's been good to me so far."
|