Re: Throw up some pictures of your rigs! I wanna see ‘em
Quote:
Originally Posted by jmon1123
Thank you king, planning to swap in a t5 and figured i could get away with buying a 350 bell housing adapter
|
Not sure I understand which way you're going with the T5, but if you intend to bolt it to a 292 bell housing you need to cut a spacer. The T5 front bearing housing is just a little smaller then the 292 bellhousing hole. (The old rock-crushing 4 spd had a slightly bigger bearing housing.)
A couple of photos:
__________________
'68 Short C20 Flatbed Dually
w/ 292 4bbl, Langdon cast headers,
and WC T5 trans.
'81 G10 Shorty Van
"Good judgement comes from experience, and a lot of that comes from bad judgement." Will Rogers
"Under promise, then over achieve."
|