[Mains52]

Was able to get some time in the shop this last weekend and I got my shocks installed up front then started prepping for my 4 link install. Found some scabs on the frame under the old leaf spring mounts, so I had to make a couple of patches. Of course I ran out of shielding gas so I had to switch over to flux core. I figure just for little patches and tacking in my 4 link the FC .030 will be fine. The new VULCAN welder works surprisingly very well. As far as the 4 link goes I am measuring everything 1000 times because I am so new to building a chassis it sort of freaks me out ha . Also any of you that have went this route or something similar did you use the stock 116in wheelbase?