Quote:
Originally Posted by SkinnyG
Do you have pictures of how you did the fuel filler?
|
The bed is still off the truck, so I haven't hooked it up to the gas tank yet. I "think" I am going to use a flexible fuel hose, but not sure yet. I will need to figure out the bends and length after the bed is installed. Both the Boyds Welding gas tank and cap use a 2" ID hose.
This is the one I bought for pictures and measurements.
PS--The hole was already in my fender from the PO and a generic fuel cap. I sat the cap in the hole and lined it up and used a spring loaded punch to mark 2 holes...Drilled and attached then marked the remaining holes and installed.