Quote:
Originally Posted by Skymortar
HTE is just like an RP. I wont get into the weeds on this but I think think they make some of these names up. It's the same setup as any gun. All clears are a little different but the HF gun likes about 28-31 psi at the gun. It's a little confusing because they always say like 15 psi at the cap.which is where the low pressure and reduced pressure come in. That all about VOC compliance. I like to back my fluid knob out wide open with a full fan. It should be a nice V without it getting squirrelly on the edges
|
Good Info. Skymortar....I have been using Nason Select Clear with good results on some smaller parts on my build, like inner fenders & Rad support. Want to get going on the overall paint on my truck....will def. look into that HF HTF gun.