Quote:
Originally Posted by HO455
The cable is firmly seated in the bracket.
I cannot pull the cable out far enough to get the end to go on to the pin on the throttle arm with the cable in the bracket.
The first 2 photos I posted are of my truck.
I don't understand what you have written here.
"you should feel the lever in the trans push the valve in, then a little more pressure to get to the last cable out position.
If you can feel the valve move, the cable is most likely not installed correctly inside the trans."
|
"you should feel the lever in the trans push the valve in, then a little more pressure to get to the last cable out position.
If you can feel the valve move, the cable is most likely not installed correctly inside the trans." refers to a check you can do to make sure the cable and linkage inside the trans is not binding up and restricting movement...
I just noticed the carb end of your cable has a simple round attachment end...most TH 350s have a cable that has an elongated slot as per link pic below...perhaps the cable is not the correct one...
These cables come in several different lengths..40" and 42" come to mind...
42 "
https://www.summitracing.com/parts/p...CABEgKmwPD_BwE
40"
https://www.summitracing.com/parts/a...SABEgItHfD_BwE