The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - 47-55.1 Project "Bickle" 1948 1/2 ton 4.3 4l60e

Father&son56project · 06-28-2020, 06:43 AM

Joedoh, I’m looking at your column pics because I am at exactly the same point in my Fargolet build. Just so I understand what you did, I assume you used an aftermarket 1” DD x ¾ DD u-joint at the bottom of the column (inside the cab and enclosed by that rubber seal), attached to a ¾ DD shaft that passes through the firewall & seal, and then a ¾ DD x 30 spline u-joint at the steering box. Do I have this right?

Stephan

06-28-2020, 06:43 AM	#19
Father&son56project Registered User Join Date: May 2009 Location: Grey County Ontario Posts: 207	Re: Project "Bickle" 1948 1/2 ton 4.3 4l60e Joedoh, I’m looking at your column pics because I am at exactly the same point in my Fargolet build. Just so I understand what you did, I assume you used an aftermarket 1” DD x ¾ DD u-joint at the bottom of the column (inside the cab and enclosed by that rubber seal), attached to a ¾ DD shaft that passes through the firewall & seal, and then a ¾ DD x 30 spline u-joint at the steering box. Do I have this right? Stephan