[TA_C10]

Update - Seat Lowering brackets


I'm 6'5, and for now I decided to keep the bench seat. So to make it work, I had to lower the seat. Turns out the kit from brothers trucks doesn't work with the high hump trans tunnel so I couldn't go that route. I ended up grabbing the Full Custom Fabrication lowering brackets. Pretty decent. And they both lowered the seat and allowed me to slide it back all the way into the back of cab. I have enough room now it should work out.

I do still plan on phase II maybe cutting into the rear of cab and sliding bucket seats in there like they did on Iron Resurrection show for the big football player. We will see.

I got some photos with the tilt steering wheel up and down so pay attention to the distance between the big grant steering wheel I have and the seat. Also remember I had my steering column rebuilt and shortened 2". It really is a good combo for us tall dudes having both of these mods done.





















Steering wheel up:




Steering wheel down:







That is the end of my modeling career...