The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

bigmoe · 07-21-2020, 05:37 PM

Rodstored, Do you have the plug or some of that end of the wire? I think you need the diagram like the one Kipps posted except for your year. Then it's as simple as extending the wires from the ecm. I think it's rare that you get that end of the factory harness fully intact that goes down to the pedal because it's really hard to get out the way it snakes through the firewall so they usually cut it off. If you can get some of the far end at the pedal from your donor or from a same model at a wrecker you should be able to figure it out, extend the wires and piece it together.

07-21-2020, 05:37 PM	#12
bigmoe Registered User Join Date: Oct 2014 Location: Brandon, Manitoba, Canada Posts: 956	Re: Where do the pedal wires go? Gen IV Rodstored, Do you have the plug or some of that end of the wire? I think you need the diagram like the one Kipps posted except for your year. Then it's as simple as extending the wires from the ecm. I think it's rare that you get that end of the factory harness fully intact that goes down to the pedal because it's really hard to get out the way it snakes through the firewall so they usually cut it off. If you can get some of the far end at the pedal from your donor or from a same model at a wrecker you should be able to figure it out, extend the wires and piece it together.