Quote:
Originally Posted by SCOTI
Here's an image of a shop built notch. Not much clearance gained for the work but it is what it is. I bet if you extended the plating on both sides of the frame to where it's just below the floor (box the inside of the rail & plate the outside portion), you gain strength & could go ~3" into the rail. wouldn't have to cap the top off making it an easier install (as long as it doesn't trap moisture).
|
Thanks for the picture! Is that a blazer by chance? Mine doesn't have the crossmember right above he notch like that one. I will box the inside for sure, and I was also thinking of running it higher and filling in some of the gap between the frame and the floor.