|
Re: 51 Chev on a S10 frame, named Dale
Hi Guys,
Nothing exciting, but, installed S 10 parking brake assembly with front and intermediate cables. When I replaced the inner kick panel I welded another piece of metal to the inside with 3 weld nuts to accept the parking brake assembly. Before install I also cut and glued some jute to the kick panels.
Had to cut an intermediate cable, and route front cable to take up some excess, and raise cable over exhaust and drive shaft.
Then bled the brakes, adjusted rear brakes, and installed rear wheels and spacers. Used impact gun with loctite on those 1 1/4 inch spacers...... also cut excess off of U bolts.
Also added Power Steering Fluid, Coolant and Oil.
Still need to bleed the clutch, and prime the oil system, but getting closer to start up.
|