[roll_the_dice]

So I tried to install my radiator last week, but the radiator bracket didn't work...I had a "modified" 6 cylinder bracket that was bent to work with the PO's v8 radiator. So I found an original V8 bracket on ebay and bought it. I received it today...I opened the box and made sure it fit the radiator...success! Then I used my media blaster to clean it up. Here are before and after. Going to either paint or powder coat it tomorrow.

Also got back to work on the bed liner. Finished the front of the bed...now to finish the drivers side panel tomorrow...I already have done 24" or so on it...so it shouldn't take too long. I will say Goof Off paint stripper is strong! Works much better than the other I had...I hope I have enough to finish!