Re: Starting 1966 Factory Short Bed Build, Bagged, 383 Stroker and Muncie M20 4-Speed
Ok, so i go out to start getting parts final cleaned for powder coating and first thing i start with is the side vents. So, i had to clean them up and found one small area that will need some very small repair which i do not mind. This is after i dismantle them. What i was not happy with is the seals. I can find them but after much research i found that the seal is sandwich between two parts that are riveted together. So i plan to remove the rivets, blast them, clean them and then get some foam.
|