[mongocanfly]

Getting ready to put my shifter in...I knew I wanted a round shifter boot..they're harder to find than I thought...wound up one for a kenworth is just what I needed..problem is they dont come with a hold down ring...so i just made one...well a actually 3, but only one good one..I was trying to use my plasma torch and circle cutter to cut these out...but my plasma was acting up and made a mess outta the first 2..so I cut one 1/4" bigger od, and 1/4" smaller id, then stuck it in the lathe and finished it up...turned out nice..
Made it from 1/8" plate..