The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

LS short box · 09-18-2020, 10:02 PM

Thanks for the kind words. It was a good project. If you go this route make sure you really clamp down the 22 gauge to a piece of wood on a good drill press. The 5" hole saw wants to walk a bit. Cut the holes first before you finish the outline of the 22 gauge.

09-18-2020, 10:02 PM	#13
LS short box Registered User Join Date: Jun 2015 Location: Carlos MN Posts: 1,962	Re: Blank METAL instrument bezel?? Thanks for the kind words. It was a good project. If you go this route make sure you really clamp down the 22 gauge to a piece of wood on a good drill press. The 5" hole saw wants to walk a bit. Cut the holes first before you finish the outline of the 22 gauge.