I did this awhile ago but one other thing i got done was the powersteering lines.
The Evolution metal saw. It works great, cuts easily through metal. I definitely cut the metal outside in the driveway because it sends shavings everywhere.
The width of the rear tire.
Well that's finally it gents. I am waiting on a few parts here and there to finish up the rear brakes. Need to bench bleed the master cylinder so I can finally bleed the whole brake system.
Did some measurements for the driveshaft. Waiting on a friend to see if it's possible for an aluminum driveshaft, otherwise I will be going with a Denny's driveshaft.
Finishing up the plumbing for the transmisison.
I am also trying to get the wiring sorted out. Will not be pretty, but at least so i can get the engine primed, and ready for a break in.
Till next time.