|
Re: Pulling motor question
Helped a guy once put a 235 in his 56 truck. Couldn’t lift it high enough due to low ceiling height in his little garage. Dropped the front down by bleeding all the air out of the tires.
Couldn’t roll it outside as there was 3 feet of snow by the door.
We layed the motor and trans down flat on the floor on the drivers side. Picked it up flat like that. Cleared the sheet metal and barely missed the roof. Set it gently down in the engine bay On blocks. Adjusted the chains and uprighted it gently into position. Worked like a charm.
Sometimes you gotta think outside the box!
|