[TA_C10]

Old school methods. As you all know, from the factory our c10 wiper motor and washer pump were mounted in the cab under the dash. So when I smoothed the firewall I decided to relocate the washer hose grommet inside the cowl to keep those hoses hidden. Got the new hoses ran tonight. Pump works! Finish hose routing when I start putting the truck back together.

I picked up the washer hose kit from Classic Industries. Very good rubber. Should last long time. And the lengths are pre-cut to fit factory, even though I re-routed things the lengths are still pretty much the same and should work just fine.

https://www.classicindustries.com/pr...rts/t1449.html







I may or may not route my water bottle feed line like this. I'm trying to figure out if I can route it down the inside of cowl instead of outside of cowl for feed, but I already have my fender installed ugh....