[88Stanger]

Ok everyone, i am in need of some advice. I am now ready to replace the inner and outer header panels where the windshield goes. Here is my question:
1.) Do i do outer one first then inner or inner than outer or ???

2.) use the entire patch panels or cut as needed? .

3.)The inner panel only has the hole cutout for the driver side sun Visor, no idea why only the driver side.


4.) Any good hints for doing this would be greatly appreciated.

Note: You will see in the first pics that i decided to make a new Cab support roller. The original one is really just to tall.

Thanks for any help!!