Re: Rodstored-72's 1986 DD build
Well after a little break of fixing my table it was back onto the truck. I decided it was time to go thru the front suspension & install the new pieces that I purchased. I tore the front down to just the frame & crossmember. I cleaned everything up and gave them a good sanding and scuffing. I wiped everything down with wax & grease remover and then proceeded to spray a few coats of POR-15 on everything. The suspension pieces that were not being replaced I did the same thing to. Side note: cleaning all 4 control arms was a daunting task. If I am in the same position again, I will choose to do what I did on my ’72 and just take them to get powder coated. Anyways here is a few pics of when I started and during the process.
|