View Single Post
Old 12-01-2020, 09:32 AM   #23
Green Monster
Registered User
 
Green Monster's Avatar
 
Join Date: Mar 2006
Location: Malvern, PA
Posts: 951
Re: Headers to 2.5" Ramhorns

Quote:
Originally Posted by DeadheadNM View Post
The heat stove should fit but it’s a guess whether or not the OD of the riser tube to the snorkel would slip over the male end at the riser and it’s in the correct location. I wonder if there is a member here who has that gen vette with the riser who could take a measurement? The stove assembles with hex head short #8 screws if I recall (maybe #10?).

The plug shields will work I suspect. But, of the four there is at least one, that to the front LH head, that’s a different shape. The shield at this location is “tented” so to speak or an inverted V to encompass the temp sending unit. Offhand I can’t recall if that at the TCS sending unit was the tented style. If helpful, I can post photos of an oem shield in this style and the hex head bolts that secure these in place.

Thank you for the info. I can't find info on the OD or the stove pipe of the C3 vette.

Are these four the correct spark heat shields? One appears to be "tented" for the thermostat.
Attached Images
 

Last edited by Green Monster; 12-01-2020 at 10:34 AM.
Green Monster is offline   Reply With Quote