Quote:
Originally Posted by 350TacoZilla
What about just forming the metal plate down on that one side to follow the tunnel shape? Maybe too much of a turn for the boot material to bend?
|
You know, upon re-reading your comment, I think we were both on the same page. The sheet metal that I bent up was only for basic mock up purposes and then the shop did the pro level work. And now the shifter boot will have a nice flat surface on which to sit.
And this week has been good too. Front and rear glass is in with the front being new and re-using the existing rear one.
Exhaust is finished with two inch pipes from the manifolds into a three inch single pipe with a cat and magnaflow muffler.