Hello;
Well I found out what I was doing wrong.
A friend come by n I told him what I was having problem with. He looked at the weld I had down.
Then he had me get two other small sheets of the fenders n put them together with my clamps.
Then he did a couple of welds at different setting.
Come to find out that I was on 1 feed min heat - wrong
He set it at 1.5 feed on min heat - better
Then he set it at 2 feed on min heat - better
Then we went to 2.5 feed on min - burn thur
So found that I as to low feed. I all so had not cleaned the back side of the fenders so will do that before I start on the NEW black fender.
So if this setting works out - I'll post NEW pics.
Thanks Guys:
T-P Auto
Tim