Re: Flatout C4 install
Ran into a delay, and wanted to share.
I was ready to tack in cross member and mock up for centering wheel in fender when I leveled the cross member side to side and front to back. I checked the angel on the upper A arm attachment points. I saw there was over a 1 degree difference side to side. I was concerned because the package was damaged when delivered. The box had large holes in it and was rough handled. Don got back to me and emailed that the variation is not unusual and can be shimmed when they do the wheel alignment.
I just wanted to share this in case anyone else sees this as they install a cross member. I will be moving ahead with my installation now.
Last edited by Rickysnickers; 01-10-2021 at 07:35 PM.
Reason: Rotated photos
|