Another lowering thread.
Hello,
The front I have 2.5" spindles and 3" springs. and rear, 3-5" springs (guess depends on weight in back, long bed would drop more than a short)
And 2.5" blocks.
Should I Assume I will need a c-notch. And the no hop trailing arm cross member mounts.
The front springs might change to 2" if the 3" drops it too much.
I figured the 50 year old originals, had sagged at least an inch. So going by where it sits now+1" . won't know till the parts go on.
The rear will Then need adjustment to my ballpark needed drop, to level it to front. will do that with the blocks,
Should I just plan on notching, and the long arm mounts?
I know I will be needing shims to get the pinion angle in check, have those.
The shock relocation brackets, I am going to assume will be needed, Some say they put the shocks outside the frame, does that limit wheel width? Are they all outside the frame rail?
|