The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Poor Quality reproducion tail light housings

Accelo · 01-25-2021, 12:16 AM

I just received my reproduction tail light for my C10. All from the same vendor. CJ Pony Parts. The lens have a tab so they can't be installed upside down.
The housing is missing the hole for the tab. The only way the lens can be installed is if I cut off the tab from the lens. Decent parts otherwise. Just one small detail from being correct!
The housings were not that expensive but when it all said and done I don't have the screws to attach the lens either. All the parts had to be ordered separately as best as I could tell.
Poor gasket fit as you can see. There is a screw hole under the gasket.
Possibly it was my fault but a kit with both sides and all the parts would make life easier for everyone.

CJ Pony Parts.Customer service is none existent with 1.5 hour wait times. Last order ever for them.

01-25-2021, 12:16 AM	#1
Accelo Registered User Join Date: Mar 2015 Location: washington Posts: 2,177	Poor Quality reproducion tail light housings I just received my reproduction tail light for my C10. All from the same vendor. CJ Pony Parts. The lens have a tab so they can't be installed upside down. The housing is missing the hole for the tab. The only way the lens can be installed is if I cut off the tab from the lens. Decent parts otherwise. Just one small detail from being correct! The housings were not that expensive but when it all said and done I don't have the screws to attach the lens either. All the parts had to be ordered separately as best as I could tell. Poor gasket fit as you can see. There is a screw hole under the gasket. Possibly it was my fault but a kit with both sides and all the parts would make life easier for everyone. CJ Pony Parts.Customer service is none existent with 1.5 hour wait times. Last order ever for them. Attached Images Last edited by Accelo; 01-25-2021 at 03:24 AM.