Quote:
Originally Posted by truckster
This is the part I used. I had to do some digging in my email, because I started building this in 2016... It was Speedway, not Summit.
https://www.speedwaymotors.com/Tight...Query=91013385
In the picture you can see where I had to cut and rotate the tube to line it up with the collector flange. I looked through my build pictures and this is the only one I have of the exhaust, but if you need more I can get some for you on Monday.
|
Thanks for the pic. How much of the "vertical" section of pipe did you have to cut to make this fit? Best I can tell there's 4-5" of available clearance from the crossmember below the manifold outlet, which means I'd think you'd have to cut and weld the flange on right at the start of the 90 in that pipe.
If you can get another photo or two without much trouble I would appreciate it.