Rear Coil Spring removal?
I'm about to install rear drop springs in my 64.
I was able to remove the upper coil spring retainer and bolt without too much trouble, but the lower retainer gave me fits.
I raised the frame to get the tension of the spring, and it was clear by about an inch.
I was not able to get a socket on the lower bolt as it was partially recessed into the control arm, is this normal?
Should there be a washer between the bolt and the control arm
How do you remove the lower retainer??
Last edited by kens65fb; 04-14-2021 at 08:22 AM.
Reason: ...
|