Re: 53 Surburban "Family Truckster"
I installed my driver seat (temporarily) to allow me to mount my throttle pedal and cable. I was fearing the worse with the throttle pedal as I needed to make a mount and since my firewall was painted it had to be a bolt in solution. The mount I made years ago was a weld on solution. I was pleased how well it all turned out. Most people that use these throttle bodies to simulate a carb use the drive my wire solution. For this reason, I needed to make my own bracket to hold the throttle cable. It turn out very clean. And get this.......it works great!!
So I fired the motor again with a throttle cable which allowed me to rev on it. I was blown away at how bad ass this motor and exhaust sounds. I laughed that I screwed up and build a race truck..ha ha. I will post a video on my IG page (Greenfield_speedshop) later this week. Even my 16 yr old son ran out to the garage for a closer look. That can attest to how good its sounds to get a 16yr old to react that fast. ha ha
This was the first time I sat in the seat in the Suburban. The seat is so comfortable. Looking forward to some quality seat time this summer.
I also installed my driveshaft that I had shortened and picked up Friday.
Thanks
Marc
Last edited by youngrodder; 04-26-2021 at 10:09 AM.
|