The Truck “Buddy Buckets” are mounted on a frame that uses the same setup as the Bench seat, and both seats move as one.
I put Blazer buckets in my truck.
The mounting brackets are different length on the drivers seat and the passenger seat flips forward with a pivot hinge on the front and a locking latch on the rear.
I fabricated the frames under mine, and used the sliders off two old bench seats.
The outside bracket on each seat is mounted in the factory holes, and I drill holes for the insides with an extra reinforcement plate for safety.
The only tricky problem I had was the adjustment lever on the passenger side is on the left side next to the console.
I solved that issue by cutting the lever shorter and fanned a bracket and over mounted to the front leg.
It works pretty good
