Quote:
Originally Posted by Rickysnickers
I apologize in advance as this may sound like a stupid question. How did you measure for the shifter and make the hole so tight so that it just fits? There's a gaping hole in mine for the floor shifter, that was already there.
|
Never a stupid question when your looking for an answer. All I did was measure from the edge of the trans tunnel to center of the shifter, and the width, measure from the front of the shifter in park and the back of the shifter in 1st and cut a small hole. Removed my shifter knob so it would slide over, then I took a sharpie and marked the edges where it was tight and used an end grinder and burr bit to slowly open the hole until it fit perfectly.