Had a mad dash to get my truck ready for the C10 Intervention which included a 2 hour drive to get there. I rode up with the local C10 club to increase the likelihood someone would pull over to help if I did break down. A picture before I left.
![](https://live.staticflickr.com/65535/51418756410_01e60c7ed9_b.jpg)
I didnt get any pics while I was there. Only issues I ran into is that the cab is a god damn oven with no insulation and my original differential vent was too low and sprayed my truck down with gear oil by the time I got home. It seemed like a lot but was probably a bit more than half a quart when I refilled it. Ill flush it out again just incase and hope for the best. No issues or noises yet. Made a new vent for now.
![](https://live.staticflickr.com/65535/51466672561_90392474c0_b.jpg)
Drew up some more stuff in CAD and had it cut. Used silicon bronze to braze up the bend reliefs.
![](https://live.staticflickr.com/65535/51465912642_1de52410f0_b.jpg)
None of it will really be seen but I polished the stainless to try to get the bronze to show through. This is the mount for the remote control holder.