Re: Need little bag over axle advice
Quote:
Originally Posted by kev2809
ohhh I see so if I drop in the drivetrain....I would measure the output shaft degree....and it has to be within 1 degree of the axle yoke...right?
|
Ideally, yes. Less than 1° difference but not equal/zero.
Manufacturers say the needle bearings in the joints need just a little difference to help them rotate.
__________________
67SWB-B.B.RetroRod
64SWB-Recycle
89CCDually-Driver/Tow Truck
99CCSWB Driver
All Fleetsides
@rattlecankustoms in IG
Building a small, high rpm engine with the perfect bore, stroke and rod ratio is very impressive.
It's like a highly skilled Morrocan sword fighter with a Damascus Steel Scimitar.....
Cubic inches is like Indiana Jones with a cheap pistol.
|