Quote:
Originally Posted by Captainfab
What bore size is your clutch master? For that hydraulic release bearing it should be a .750" bore. The clutch pedal shouldn't be that hard to push. A hard pedal is often times a clutch master with a bore size that is too large. The object of the linkage assembly on the inside is not so much to achieve a certain pedal ratio but more so to achieve a full pedal travel while not overstroking the clutch master.
|
I have the 3/4 master that came with the kit. And i understand the reasoning of the lever on the master assembly, i was more referring to the pedal side of the pushrod. If comparing the mechanic leverage from the factory location and the new location, the pedal ratio changes drastically. I will redo my measurements this weekend, but i do think the pedal pushrod should be mounted closer to the pedal pivot