|
Re: Anyone using the DIY4X Engine Cross member?
Put the original design in first, called DIY, and asked him if he could put flanges on it, to make it a 3 piece design.
I've had to change oil pan a couple times, and. It sure makes it easy, just mark the front of the center section as it may bind, no problems with reassembly with just the motor mounts holding up the engine
Hardest part was getting the old cross member out
__________________
Semper Fi...Uncle Sam, you da man
All parts offered to help are free, unless otherwise noted
Dont try this stuff in my build thread, unless you have 55 years of mechanical OTJ training
SAFETY FIRST
AS usual, off topic
They say your mind goes second, can't remember the first
Jim
|