|
Re: Doing LS Swap - I have no idea what I'm doing!
It's not much, but I did get a plug for the sensor and installed it this past weekend. Then had a couple of minutes to hook up the ground on the wiring harness and hooked up the connections for the transmission. I was going to start hooking up the knock sensors and the starter, but my kids started waking up from their naps and I had to call it quits.
So, I'm down to O2 sensors, knock sensors, and the starter for the main harness. Then figure out how to mount the ECM and then wire up the individual wires to the truck. I still need to get the gas tank mounted and fuel lines run.
Those of you that have used the Wrangler tank, how did you run the filler neck? I'm still trying to figure that one out.
|