[Blazerowner]

I would document it here. I’m definitely wanting to do this in the future myself. Hope it goes well for you.

Originally Posted by harrij4

After having this particular project sidelined for a couple years because of a bunch of other projects ...oh, and a global pandemic... I'm finally ready to go! I ordered the Amp Research 75122-01A configuration for a few reasons:

- Brackets shouldn't require machining since they seem to mount horizontally
- Uses default ground-switching to trigger instead of OBDII
- Default step width is pretty close to the rocker-length on a '72 K5
- I thought the rounded step profile better matched the K5 than the sharper flat/edgy profile

I think I'm going to take a similar approach to the person earlier in this thread who made a plate/angle bracket, but we'll see. Should I document the process in this thread, or a new one?