The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Turning Issue. SOLVED!! Center-link

**Accelo** · 08-01-2022, 03:58 PM

Yup, just went through this. They are backwards. It will drive so much better you will not believe it. Toe in will have to be adjusted. Mine was way out after I swapped the center link. You will have to turn the wheel hard over to get it installed as there isn't enough room to install the center link with the wheels straight. Per LocDoc's recommendations install 90 deg fittings to allow for greasing if they are not already installed. Remember "NUTS FORWARD" is how it's installed.
Cheers.

08-01-2022, 03:58 PM	#13
Accelo Senior Member Join Date: Mar 2015 Location: washington Posts: 2,184	Re: 2 1/2 " Drop Spindle Question - Turning Issue. Yup, just went through this. They are backwards. It will drive so much better you will not believe it. Toe in will have to be adjusted. Mine was way out after I swapped the center link. You will have to turn the wheel hard over to get it installed as there isn't enough room to install the center link with the wheels straight. Per LocDoc's recommendations install 90 deg fittings to allow for greasing if they are not already installed. Remember "NUTS FORWARD" is how it's installed. Cheers. Last edited by Accelo; 08-02-2022 at 09:41 AM.