Quote:
Originally Posted by Joyridin
I highly doubt .010" would even break the RTV seal. RTV flexes more than that.
Are you sure your torque converter isn't massively out of balance or something? Again....010" isn't going to mean anything on the oil pan.
|
I suspect that the converter could be a source of the problem. It was new when I installed the trans and my transmission builder was able to clean up the snout and we reused it this second time. I've never heard of a converter with bad runout or balance problems, but I don't have access to a lathe to check it.
I've thought of just bolting it to the flexplate without the trans, but I suspect it will just distort the flexplate due to the weight and make it difficult to get a runout measurement. I should mount it just to see how the crank fits.